Hill is new and high taste handle of Steadyline face milling cutter

  • Time:
  • Click:161
  • source:LAURENDA CNC Machining
Steadyline is the knife handle that an application reduces damp vibration directly at face milling cutter. The design concept of this cutting tool is to achieve " long dangerous extend Ju Xiaozhen to move " the effect, the vibration isolation that says popularly namely. System of this kind of knife handle enhanced the tigidity when milling thoroughly, growing hang extended case to fall, cutting parameter can reach a new height, even the milling cutter with average length is same. Stable cutting condition can improve treatment technology, decrease vibration and add cutting tool life. The solution of this kind of oscillatory damp that SECO develops, although growing,hang extended operating mode to fall to also can assure first-rate stability. Steadyline offerred to be decreased dynamicly brace up system. In knife handle interior, a vibration absorbs the vibration with the first contrary vibration that device undertakes bending with knife handle is out of shape arising, because this can absorb vibration, the trends that increases milling cutter combination significantly is rigid, make treatment stabler. The dynamic stability of knife handle of Steadyline face milling cutter is 3 times taller than congener and common knife handle. No matter be,which kinds grow dangerous extend milling, it is to grow diameter comparing to achieve 5 times even, cutting parameter can hold best position from beginning to end. Combine photograph comparing with traditional module, the cutting deepness of Steadyline is OK tower above 2 ～ 4 times, handling time shortens half, can improve manufacturing efficiency greatly for the client. Apply extensively at growing diameter to compare to be on milling cutter of 5 times square shoulder milling cutter of the left and right sides, corn milling cutter and tall feed at present. With respect to quality of metallic purify rate and treatment surface character, the factory will get better treatment result, main shaft life and cutting tool life increase considerably. Steadyline was solved all the time since the difficult problem that puzzles expert of a lot of cutting, that is growing namely hang length state to fall, cutting effect and the problem that machine efficiency. Apply in mould treatment a few deep model the complex integral type part in the antrum treatment, treatment on horizontal machining center, aerospace and auto industry, and generate electricity the spare parts of equipment, a lot of application that expanding can use Steadyline technology to optimize. CNC Milling